Talley Manufacturing Scope Rings Features The Talley Manufacturing Scope Rings are machined from steel bar stock giving them the strength to hold a scope securely under recoil without the moving parts that can loosen over time on lesser ring designs. These rings use the same double recoil shoulder base found on Talley s Quick Detach rings a design intended to prevent scope movement even under the hottest loads a rimfire rifle might see. Precision cut dovetails are machined at the correct angle to seat exactly onto an 11mm dovetail receiver ensuring the rings mount flush and true without gaps or play. Torx clamp screws allow the user to snug the rings down tightly delivering strong consistent holding power on the scope tube. Sized to accept 1 inch scope tubes these rings are built in a High 0.6 inch height configuration giving the shooter the clearance needed for larger objective bells or iron sight co witness setups. The Black matte finish gives the rings a clean professional appearance that matches most rimfire rifle finishes. Sold in pairs as is standard for ring sets these mounts are ready to install directly onto a dovetail equipped rimfire receiver without needing a separate base. For Anschutz and other dovetail rimfire rifle owners looking for a dependable vibration resistant scope mounting solution these Talley rings are available from GrabAGun. Talley Manufacturing Scope Rings Specifications Manufacturer: Talley Manufacturing Type: 11mm Dovetail Rings Material: Steel Finish: Black Matte Scope Tube Diameter: 1 Ring Height: 0.6 High Compatible Hosts: Anschutz and Other 11mm Dovetail Rimfire Rifles Available At: GrabAGun