Breek Arms Warhammer Mod2 Features The Breek Arms Warhammer Mod2 is machined entirely from 7075-T6 aluminum and finished with Type III hard coat anodizing for added strength and long term durability. Textured grooves cut into the latch handles give shooters a sure grip when charging the rifle even while wearing heavy gloves. The wide set back latches are designed to clear large optics mounted on the receiver avoiding the interference that smaller charging handles can create. At just under 1 ounce the handle adds negligible weight to the rifle while replacing the factory part with no gunsmithing required making installation as simple as swapping in a mil spec component. Breek s Mod2 design specifically targets gas blowback cutting relief channels on the top and bottom of the stem to direct excess gas out to the side rather than back toward the shooter s face. For gas that does escape rearward an increased rear shelf height better covers the back of the upper receiver keeping fouling and hot gas away from the shooter s eyes and lungs. These changes make a noticeable difference when shooting suppressed where gas blowback is typically at its worst and where a standard mil spec handle leaves shooters exposed to the most irritation. The oversized ambidextrous latches also mean left handed shooters get the same fast intuitive charging stroke as right handed shooters with no need to break their firing grip to run the gun. Finished in OD Green and made in America the Warhammer Mod2 fits all mil spec AR-15 and M16 rifles as a drop in replacement giving owners a straightforward way to improve reliability and comfort without a full upper rebuild. Breek Arms Warhammer Mod2 Specifications Manufacturer: Breek Arms Model: Warhammer Mod2 Compatible Hosts: Mil Spec AR-15 / M16 Rifles Color: OD Green Material: 7075-T6 Aluminum Finish: Type III Hard Anodized Width: 2.78 Weight: 1 oz Available At: GrabAGun