Cast SFX DH/Enduro 35 Handlebar Quantify Your Setup. Own the Line. When your terrain is steep, rowdy, and unforgiving, your bar position matters as much as your suspension tune. The SFX DH/Enduro 35 was developed alongside the Norco Race Division and Greg Minnaar, shaped by riders who need exact confidence at speed. The 7075 alloy construction keeps the bar stiff where it counts, with enough tuned compliance to take the edge off chunk and chatter without going noodle on you. Engraved position markings let you dial your brake roll, lever angle, and bar roll once, record them, and hit the same setup every time you swap builds or hand the bike to a mechanic. Features 7075 alloy construction high-strength alloy tuned for the stiffness and compliance demands of DH and enduro terrain 800mm width maximum control on technical, high-speed descents with room to trim for fit 35mm clamp diameter stiffer cockpit interface suited to DH and enduro stem clamps 35mm rise with 8deg backsweep, 5deg upsweep / 38mm rise with 9deg backsweep, 6deg upsweep two rise options to match frame geometry and rider position preference Engraved position markings quantify brake roll, brake position, and bar roll for repeatable, consistent cockpit setup Specifications Material7075 Aluminum Alloy Bar Clamp Diameter35mm Width800mm Rise35mm, 38mm Back Sweep8deg (35mm rise), 9deg (38mm rise)Up Sweep5deg (35mm rise), 6deg (38mm rise)Weight313g (35mm rise), 305g (38mm rise)Intended Use Enduro, Downhill | Cast | Sfx Dh/enduro 35 Handlebar | Black | 35Mm X 800Mm | Aluminum