RCBS Wadcutter Pistol Bullet Mould Features The RCBS Wadcutter Pistol Bullet Mould casts a long wadcutter bullet at .314 inch diameter and 98 grains sized for the .32 WCF .32 SW Long and .32 Colt NP family of cartridges. Its two cavity design lets a caster produce bullets in pairs speeding up a casting session compared to a single cavity mould. The solid cast iron block construction resists warping from repeated heat cycles so the mould holds its dimensions casting after casting. A 3/16 inch sprue plate held firmly in place with spring washers and tempered steel screws makes cutting the sprue quick and clean. Precision ground square blocks mated with steel alignment pins keep both cavity halves perfectly registered which is what produces consistent accurate castings rather than bullets with visible mould lines or inconsistent weight. Handles are not included with this mould and must be purchased separately so casters already running RCBS handles can add this mould to their lineup without buying extra hardware. The Casting Bullet Type is a long wadcutter favored by revolver shooters loading target and plinking ammunition. This mould is a solid choice for any home caster building their own supply of .32 caliber wadcutter bullets. RCBS Wadcutter Pistol Bullet Mould Specifications Manufacturer: RCBS Item Type: Mould Bullet Type: Long Wadcutter Caliber: .32 WCF / .32 S&W Long / .32 Colt NP Bullet Diameter: .314 Bullet Weight: 98 Grain Number of Cavities: 2 Mould Material: Cast Iron Handle: Not Included Available At: GrabAGun