Assembled slide for the Glock 19 Gen 3 - Stiffler Manufacturing Zoom RMR-cut, shop-built at 3CR Tactical. The black Cerakote Zoom slide is paired with a Oil Slick (PVD Multicolor) 9mm barrel and Standard-height polymer sights (front white dot) - ready to drop onto a Gen 3-pattern frame. What is installed: Machined from heat-treated 17-4 PH stainless bar stock - tougher than the 416 stainless commonly used for pistol slides Color-matched RMR cover plate installed Oil Slick / PVD Multicolor crown-cut 9mm barrel 3CR Tactical slide completion kit (internals) installed Standard-height polymer sights (front white dot) Fitment: Glock 19 Gen 3 and compatible Gen 3-pattern frames (SCT, Grit, Dagger, and similar). No fitting required - drop onto the frame, cycle to verify function, and go. Optic & cover-plate hardware: RMR footprint. Cover-plate screws are 6-32 x 1/3"; optic-mount screws are 6-32 x 7/16". When installing a red dot, use the mounting kit that ships with your optic rather than generic screws. Care & break-in: Each slide is function-tested before shipping and will need lubricant and a normal break-in period. The Oil Slick PVD finish is unique to every barrel and will show contact wear over time - normal and cosmetic; treat the barrel as you would any PVD/TiN part. Photos are representative; each slide is assembled to the specification described above. Frame parts kit included This build is bundled with the 3CR Tactical frame completion kit - the lower components needed to finish a frame, bundled below what the kit sells for on its own. Trigger with trigger bar Trigger housing with ejector (Gen 3) Trigger spring, trigger pin and trigger housing pin Connector Magazine release with spring Slide stop release with spring Slide lock with two springs - one for the Glock 17 frame, one for the Glock 19 Locking block pin Kit fitment - the frame parts kit is Gen 3 : the trigger housing ships with the Gen 3 ejector. The slide itself fits Glock 19 Gen 3 and compatible Gen 3-pattern frames. What you'll still need to supply A Glock 19 Gen 3 frame and a magazine This is a slide assembly and a frame parts kit. It is not a complete pistol and does not include a frame. DISCLAIMER: "GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither 3CR Tactical nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of "GLOCK" on this page is merely to advertise the sale of GLOCK pistols, parts, or components. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.