Complete shop-assembled and function-tested RMR-cut slide for Glock 19 Gen 3 frames, built and tested in our Florida shop. Aggressive knurled front and rear grips, a Rose Gold PVD crown/flush-cut barrel, and standard-height sights - drop-in fit with no gunsmithing required. Features Knurled-grip stripped slide blank, black nitride finish - aggressive front and rear cocking grips RMR footprint optic cut with cover plate for Trijicon RMR / SRO and compatible red dots (Holosun 407C, 507C, etc.) 3CR Tactical slide completion kit pre-installed (firing pin, extractor, plunger assembly, recoil rod, cover plate) Rose Gold PVD crown/flush-cut 9mm drop-in barrel - chambered in 9mm Luger Standard-height polymer sights pre-installed - these are standard irons and will not co-witness through a mounted optic Fully assembled and function-tested in our Florida shop - no gunsmithing required Manufacturer Part Number: ASSM-G19-RMR-02AG-BN-SS-RG Specifications Caliber: 9mm Luger Compatible host: Glock 19 Gen 3 frames Slide finish: Black nitride Barrel: 9mm Rose Gold PVD, crown/flush cut (non-threaded) Optic cut: RMR footprint Sights: Standard-height polymer Finish note The Rose Gold PVD barrel finish is a decorative coating. Like all PVD/TiN coatings, it can show wear at points of metal-to-metal contact (such as the barrel hood and locking lugs where the barrel meets the slide) over time with use. This is normal and does not affect reliability or function. Optic mounting screws (not included) If you are mounting a red dot, we recommend using the screws supplied with your optic kit. The RMR cover plate uses 6-32 x 1/3" ; optic mounting uses 6-32 x 7/16" . Most Trijicon, Holosun, and aftermarket kits include the correct length. Hardware is not included with this slide. Break-in and care Lube all slide rails and contact surfaces before first use. Run approximately 200 rounds of standard 9mm ammunition during break-in before moving to duty or self-defense loads. Confirm your lower is a Glock 19 Gen 3 pattern. Frame parts kit included This build is bundled with the 3CR Tactical frame completion kit - the lower components needed to finish a frame, bundled below what the kit sells for on its own. Trigger with trigger bar Trigger housing with ejector (Gen 3) Trigger spring, trigger pin and trigger housing pin Connector Magazine release with spring Slide stop release with spring Slide lock with two springs - one for the Glock 17 frame, one for the Glock 19 Locking block pin Kit fitment - the frame parts kit is Gen 3 : the trigger housing ships with the Gen 3 ejector. The slide itself fits Glock 19 Gen 3 frames. What you'll still need to supply A Glock 19 Gen 3 frame and a magazine This is a slide assembly and a frame parts kit. It is not a complete pistol and does not include a frame. GLOCK is a federally registered trademark of Glock, Inc. and is one of many trademarks owned by Glock, Inc. or Glock Ges.m.b.H. Neither 3CR Tactical nor this site are affiliated in any manner with, or otherwise endorsed by, Glock, Inc. or Glock Ges.m.b.H. The use of "Glock" on this page is merely to advertise the sale of Glock pistols, parts, or components. For genuine Glock, Inc. and Glock Ges.m.b.H products, visit https://us.glock.com .