Factory Seconds & Discontinued Pure Beeswax Pillar Candles We&';re saying goodbye to our dyed beeswax pillars and the remainder will be available here at discount while supplies last! Otherwise, these are factory 2nd pillars that are cosmetically imperfect. There might be an odd blemish or a small air bubble on the surface of the candle. It is often the case that folks can&';t even see the flaw. Rest assured, they will burn beautifully.Many beeswax pillars have difficulty burning because the particulate in beeswax clogs the wick, resulting in a weak flame and tunneling. Our pillars will burn perfectly because we lightly filter our crude beeswax and carefully choose the right wick. Light filtration takes out just the right amount of particulate while keeping the sweet honey scent and gorgeous natural color intact. Features 100% Pure Beeswax Available in Raw, Ivory & 10 Colors, depending on stock Ridiculously long burn times Clean burning and non-toxic Cotton wick - no lead or metal See 2-inch, 3-inch, and 4-inch burn-care bottom labels above Average TOTAL burn times for our pillars (see Candle Care pamphlet/ instructions on bottom of candle for tips to get the best and longest burn from your beeswax candle):2" x 3" ~25 hours2" x 4.5" ~36 hours3" x3" ~50 hours3" x 4" ~60 hours3" x 6" ~90 hours4" x 6" ~180 hours4" x 4" ~120 hours4" x 8" ~240 hours Dimensions & Care 2" Dia. Pillars: Trim wick to 1/4" before each lighting. To avoid dripping, burn for only 1 hour at a time. To eliminate smoke when extinguishing the flame, use a tool to drip wax from the molten pool onto the burning wick. 3" Dia. Pillars: Trim wick to 1/4" before each lighting. To avoid tunneling, burn for at least 3 hours per burn and mold the warm sides in toward the flame. This will melt the walls, utilizing all of the available fuel, and thus extend the overall burn time. It will also raise the molten wax level, and shrink any over-sized flame. To prevent uneven burning and potential dripping, use a metal tool to redirect a curled or angled wick to the opposite direction. To prevent wick breakage when doing this, be sure to nudge the wick below the level of the molten pool where the wick is not burned and thus stronger. To eliminate smoke when extinguishing the flame, use a tool to drip wax from the molten pool onto the burning wick. 4" Dia. Pillars: Trim wick to 1/4" before each lighting. To avoid tunneling, burn for at least 6 hours per burn and mold the warm sides in toward the flame. This will melt the walls, utilizing all of the available fuel, and thus extend the overall burn time. It will also raise the molten wax level, and shrink any over-sized flame. To prevent uneven burning and potential dripping, use a metal tool to redirect a curled or angled wick to the opposite direction. To prevent wick breakage when doing this, be sure to nudge the wick below the level of the molten pool where the wick is not burned and thus stronger. To eliminate smoke when extinguishing the flame, use a tool to drip wax from the molten pool onto the burning wick.