Interlux Trilux Boat Prop & Drive Antifouling Spray PaintShield metal components from marine growth and corrosion with Interlux Trilux Prop & Drive Antifouling Paint. This easy-to-apply spray is formulated for underwater metals like propellers, outdrives, and lower units. It creates a tough barrier that resists fouling and slows down corrosion, helping your propulsion system perform at its best season after season. Designed for continuous submersion, it's ideal for boats in saltwater or freshwater environments. For boaters who want fewer maintenance headaches and longer equipment life, Trilux provides targeted protection where it matters most.Features: Convenient aerosol can provide effective antifouling; Interlux' exclusive Biolux technology reduces slime and increases antifouling performance; Safe for all out drive and underwater metals; Can be used in fresh, salt, and brackish water; Only available in 12 oz. aerosol can; Specifications: Size: 12 fl. oz.; Finish: Matte; Coverage (approx): 21.2 ftA^2 per spray can; Number of Coats: 1-2 as needed; Colors Available: YBA063A Black, YBA064A Gray, YBA068A White; VOC: 470 g/lt; It is important that you shake can well before use. If can is not shaken properly, clogging of the tip may occur. How To Apply Interlux Trilux 33 Aerosol PaintPrior to application, shake can well. Listen for mixing-ball and continue shaking vigorously for at least two minutes. Shake in an up and down motion. If not shaken properly, tip may clog. Application Method: Aerosol can; Number of Coats: 1-2 as needed. Use an entire can per lower unit.; Dry film thickness: 2 mils; Coverage: 21.2 ftA^2 per spray can; Application Temp: 50F Min. / 95F Max.; Dry Times: Temp To Touch To Recoat To Launch 95F 1/2 HR 4 HR 8 HR 73F 1/2 HR 6 HR 12 HR 50F 1/2 HR 12 HR 16 HRSurface Preparation Bare Aluminum:; Grind or blast the bare aluminum to a bright metal finish.; For best results, pre-prime using an etch primer.; Remove sanding residue or any dust.; Immediately apply at least 3 coats of Interprotect 2000E (first coat thinned 10-15%) or one full can of Primocon Aerosol Primer YPA985; Previously Painted Surfaces; If previously painted with Trilux 33, sand with 80 grit sandpaper.; If factory finish or antifouling paint, sand with 80 grit sandpaper then clean with special thinner 216. Resand any areas where bare aluminum is exposed with medium grit emery cloth and wipe clean. Follow the procedure for bare aluminum above.; Epoxy:; Remove all surface contamination using Fiberglass Surface Prep YMA601.; Flush with fresh water and allow to dry.; Sand with 80 grit paper, then remove sanding residue.; Wipe with Fiberglass Solvent Wash 202.; Apply Interprotect 2000E as primer.; Application At least 2 coats should be applied.; Hold can 12-16" from the unit when applying the paint.; Wait for minimum overcoating time between coats.; Continue until entire can has been used per outdrive.; Allow minimum immersion time.; Click to Download Interlux Trilux 33 Application Instructions