Area 419 Loading Block Features The Area 419 Loading Block holds 50 magnum or .308 and Lapua bolt faced cases giving reloaders an organized stable surface to stage brass during case prep powder charging and seating. Each hole measures 0.5 inch deep with a 0.56 inch diameter sized specifically for magnum case heads and is machined as a tight fit around the case to prevent tipping. A small divot at the bottom center of each hole catches stray powder kernels reducing the chance of an accident with a primer sitting in a loaded case. Machined in house from 6061-T6 aluminum the block is built to the same exacting tolerances Area 419 applies to its sizing dies and other reloading tools. Rubber pads on the bottom of the block keep it from sliding around the reloading bench during use a small detail that matters when working methodically through a batch of cases. The clear anodized finish adds a layer of durability compared to a raw aluminum block standing up to the inevitable bumps and scrapes of a busy reloading session. At 9.5 by 4 by 0.625 inches the block is compact enough to store easily while still holding a full 50 rounds at a time. For reloaders working with magnum or large rifle cartridges who want an organized durable loading block the Area 419 Loading Block is available for sale at GrabAGun. Area 419 Loading Block Specifications Manufacturer: Area 419 Model: Loading Block Caliber: Magnum Capacity: 50 Spots Material: Aluminum Finish: Clear Anodized Length: 9.5 Hole Diameter: 0.56 Weight: 1.4 lbs Available At: GrabAGun