However you take your eggs, you can't deny that Crank Brothers' Eggbeater Pedals have earned themselves a reputation rivaling the greasiest, most delicious diner breakfast — albeit for a few different reasons. Their minimalist design has earned a devoted following amongst the XC/trail set for its ease of use and reliability, with a four-sided entry and knee-friendly float and release angle options. Crank Brothers constructs the Eggbeater's main body and spindle with stainless steel, tough enough for trail use and with a mud-shedding design that will allow you to take your feet out of the pedals on short notice if you encounter a rough section of trail, then clip back in quickly to start pedaling again. The Eggbeater cleats are so small that they actually recess to sit flush with the sole of your shoe, allowing for less cleat damage and making it easier to walk around before or after your ride. A tried and true clip-in pedal for XC and trail ridersLightweight, minimalist design is simple and reliableSuperior mud-shedding to any other pedal on the marketDouble-sealed bearings are made to last season after season4-sided entry eases the burden of clipping inCustomizable float and release angles to suit your needsStainless steel construction won't rust or corrodeMaterial[spindle] forged scm 435 chromoly steel, [body] cast stainless steel, [wing] steel (stamped), [spring] 300-series stainless steelFloat6°CleatsbrassEntry / Releasecustomizable 15 - 20°Claimed Weight[pair] 10oz (285g)Recommended Usecross-country, trailManufacturer Warranty5 years