SeaStar Solutions Xtreme Mechanical Steering CableThe SeaStar Solutions XTREME steering cable was designed specifically for XTREME helms. This cable offers lower backlash and is more efficient than a standard steering cable. It provides the lowest ease of effort, a close "fit" of the core to liner for lowest lost motion. This concept provides the tight fit of core to liner yet allows area for lubrication. A quick connect feature on both the steering cable and spent travel tube allow for quick and easy installation.Xtreme Steering cables feature a super tough HDPE jacket for the ultimate protection against the elements. Oil tempered lay wires provide superior strength and performance. Additionally, a long-wearing HDPE liner is ultra soft and lubricated for life.Features: Based on the current industry leading Xtreme technology; Splined ridges on the inner liner allow close contact with core; With minimum contact the core glides freely; Tight fit for minimal lost motion; Reduced friction for extended cycle life; Robust construction support highest steering loads in the mechanical range; Click to Download XTREME Steering Cable Installation InstructionsHow to Measure Steering Cables "Measure Twice. Order Once."Replacement of Existing Cable: If possible, find the part number stamped on the plastic jacket of the old cable. If you removed the old cable, measure for the replacement cable as follows:For Rotary Steering Cable Replacement, Measure Existing Cable as follows: Measure plastic cable jacket ("Y" dimension, shown in above drawing) in inches, add 18a ^2, and round up to next foot. Order that length cable.New Installation: Measure cable routing path from wheel center line to engine connection, as follows: A = Center line of wheel to gunwale (or deck, if routed downward), B = Dash to transom, C = Gunwale to centerline of cable connection at centered tiller.For Cable Installations through the Engine Tilt Tube: Add A, B & C + 6a ^2, then round up to the next foot. Order that length cable.For Cables Mounted to Transom, Splashwell or Stringer: Add A, B & C, then subtract 6a ^2 and round up to the next foot. Order that length cable.TYPICAL SINGLE STATION ROUTINGA single-cable, starboard drive push-pull mechanical cable system is shown in this diagram. If your mechanical system is different than the one depicted and/or you have any questions about mechanical steering after reviewing this guide, please contact Teleflex (Mechanical) Technical Service at (610)-495-7011 or www.teleflexmarine.comCable routings (such as those found on pontoon boats) may vary from this drawing. Confirm length by laying a garden hose or similar object) along cable path and measure run from wheel to engine connection point.