SeaStar Rack SSC134 Back Mount Mechanical Steering Cable by DometicUpgrade the new back mount rack to dual cable steering with only a single cable change. Upgrading your steering cable allows for improved control, reduced cable play, and a more enjoyable captaining experience. This SeaStar steering cable is a natural option at an economical price through Wholesale Marine.Direct replacement for Teleflex Marine SSC134 series original factory steering cables. SeaStar Solutions replaced Teleflex Marine and has been acquired by Dometic Group.Fits: SH5210P, SH5230P (NFB), SH91610P, & SH91630P (NFB). Does NOT fit SH5097/SH5098How to Measure Steering Cables "Measure Twice. Order Once."Replacement of Existing Cable: If possible, find the part number stamped on the plastic jacket of the old cable. If you removed the old cable, measure for the replacement cable as follows:For Rack Steering Cable Replacement, Measure Existing Cable as follows: Measure plastic cable jacket ("Y" dimension shown in above drawing) in inches, add 30a ^2, and round up to next foot. Order that length cable.New Installation: Measure cable routing path from wheel center line to engine connection, as follows: A = Center line of wheel to gunwale (or deck, if routed downward), B = Dash to transom, C = Gunwale to centerline of cable connection at centered tiller.For Cable Installations through the Engine Tilt Tube: Add A, B & C + 6a ^2, then round up to the next foot. Order that length cable.For Cables Mounted to Transom, Splashwell or Stringer: Add A, B & C, then subtract 6a ^2 and round up to the next foot. Order that length cable.TYPICAL SINGLE STATION ROUTINGA single-cable, starboard drive push-pull mechanical cable system is shown in this diagram. If your mechanical system is different than the one depicted and/or you have any questions about mechanical steering after reviewing this guide, please contact Dometic (Mechanical) Technical Service at (610)-495-7011 or www.dometic.comCable routings (such as those found on pontoon boats) may vary from this drawing. Confirm length by laying a garden hose or similar object) along cable path and measure run from wheel to engine connection point.