Bore Tech Bolt Action Wiper Only
Bore Tech Bolt Action Wiper Only, Bore Tech Bolt Action Wiper Only Bore Tech's patent pending Bolt Action Cleaning Tool Wipers are the industry's most innovative and effective method for meticulous cleaning a bolt action rifle's locking lug recess and action The action and locking lug recess on a bolt action rifle has a tendency to collect brass shavings, powder residue, debris, bolt lug grease, and solvents This accumulation of debris can cause operational malfunctions and increase wear on your bolt, bolt lugs, and action In the past, these areas have been difficult to properly clean/dry and are often neglected Not anymore! Our exclusive, patent pending molded rubber wiper eliminates clumsy dental rolls and ineffective felts that fall off, barely clean, and pack full of fouling rending them useless With the new Bolt Action Wiper simply spike a patch over the rubber wiper and observe how it perfectly conforms to the action walls providing a thorough and complete cleaning in a fraction of the time The Bolt Action Wiper fits most popular 2-Lug Centerfire Bolt Action Rifles with 0 695 -0 700 bolt body diameter The Universal Wiper fits actions with 3-Lug Bolts and Smaller/Larger bolt body diameters and are easily trimmed to size for a perfect fit Are your actions Bore Tech clean??? Bore Tech - Redefining Gun CareProudly made in the USA Action Cleaning Tool Wipers Bolt Configuration/Diameter Requirements: The Bolt Action Wiper fits most popular 2-Lug Centerfire Bolt Action Rifles with 0 695 -0 700 bolt body diameter Most Remington, Winchester, Ruger, Browning, Savage and Custom Actions have a 0 695 -0 700 bolt body diameter The Universal Wiper fits actions with 3-Lug Bolts and Smaller/Larger bolt body diameters such as Weatherby, Sako, Kimber, CZ, etc and are easily trimmed to size for a perfect fit Material: Molded, Solvent Resistant RubberCore: Proof Positive AlloyThreads: Male 8/32 Bore Tech Action Cleaning Tool Wiper Use Instructions Screw Wiper onto the end of a non-rotating rod Center Spike a patch over the tip of the wiper 2 1/2 Round Patches are recommended for the Bolt Action Wiper2 1/2 Round Patches are recommended for the Universal Wiper unless trimmed smaller Next, dampen the patch with Bore Tech C4 Carbon Remover and align the wiper with the action Insert the aligned wiper into the action and push the rod forward until the lug recess is reached Rotate the wiper in the bolt lug recess while lightly pushing against the barrel face and pulling backwards against the action face Repeat with a damp patch if necessary until clean TIP: Insert the wiper 1-2 into the action and mark the rod handle at 12 o'clock with a marker Once finished cleaning and before pulling the wiper out of the lug recess area, rotate the handle so that the mark is showing at 12 o'clock This perfectly aligns the wiper with the action for trouble-free removal Finally, using a clean patch repeat Step 4 until patch come out clean/dry Bore Tech Universal Wiper Trimming Instructions To properly fit the Universal Wiper to your action, please follow the steps below; Remove the rifle bolt from the action Stand the rifle bolt up on top of a piece of paper Trace the head of the bolt on the paper Cutout the traced outline of the bolt head DO NOT CUT TOO CLOSE to the traced line The wiper works best when sized slightly larger than the actual bolt Center spike the paper cutout over the Universal Wiper tip and use as a template Orient the bolt lugs of your template per the illustration below before cutting Alternatively, use a hole punch to punch a 1/4 hole in the center of the template Trim the Universal Wiper to size following the paper template Repeat the above steps to cut the rear wiper blade to size Be sure to align the template to the previously cut wiper blade