B&T Industries Atlas Barrett M107A1 Picatinny Rail BT79
B&T Industries Atlas Barrett M107A1 Picatinny Rail BT79, The BT79 is a 5-slotted 1913 Picatinny rail for direct installation to the Barrett M107A1, and serves as a solid mounting location B&T Atlas Bipod Picatinny rail mounted bipods. The center-to-center hole spacing of 3.359" fits the outer two holes of the existing three holes in the chassis. It is strongly recommended that you measure the hole spacing on your rifle. The center section is machined to Picatinny rail standards from 4140 cold finished steel with a maganese phosphate finish. Two 3/8-16 x 3/4" flat head cap screws are provided. The original 11/16" nuts and tooth lock washers are reused to complete assembly. An 11/16" socket and ratchet wrench OR break-over bar and a 7/32" hex wrench is required for installation (none included). Installation Instructions: 1: Ensure the firearm is NOT loaded. 2: Remove the barrel and upper portion following manufacturer's directions. 3: Visually confirm the BT79 holes line up with those found on the Barrett M107A1 4: Using a 11/16" socket and ratchet wrench OR breakover bar and a 7/32" hex wrench, disassemble the fasteners and remove the bipod. Do NOT discard the original 11/16" nuts and tooth lock washers. 5: Place the BT79 on the forearm and place one flat head cap screw (FHCS) through the hole. Slip a tooth lock washer onto the FHCS followed by the nut. 6: Repeat #5 on the other end of the BT79. 7: We recommend using Loctite 263 (not provided) on the threads following the manufacturer's directions and cure times. 8: Once both FHCS are installed, torque to 25-30 foot-pounds. 9: Reassemble the barrel and upper portion to the lower portion following manufacturer's directions.